OLinda Max 140 Bar High Pressure Car Washer

Specification of OLinda Max 140 Bar High Pressure Car Washer

Volt(v)	220-240V
Freq (Hz)	Freq (Hz)
Power (W)	1500W
Rated Current	7.0A
Rated Pressure	90±5Bar
Max Pressure	140Bar
Rated Flow	5.0L/Min
Max. Water Inlet Pressure	8Bar
Max Water Inlet Temperature	50°C

What's accessories in the box of OLinda Max 140 Bar High Pressure Car Washer

1)High Pressure Gun     
•Made from high-quality ABS, abrasion resistant and aging resistant. Ergonomic design handle comfortable to hold, easy to operate.

2)High Pressure Hose 5 Meters   
Quick-connector *M22 5 meters high pressure hose. Newly upgraded strength and wear resistance,  maximum pressure does not exceed 180Bar/2610PSI and the maximum water temperature does not exceed 60°C.

3)Pressure Washer Soap Bottle  
The snow foam bottle brings a flexible and convenient operation and makes thick frothy foam covering and sticking on vehicles.
The size of soap bottle is 370ml, which is big enough for you to do a full spread on car.

4)Gun Holder and Hose Hook  
Easy installation and convenient for accessories organization.


5)High-pressure Water Filter 
Max pressure: 12Bar；Maximum temperature: 50°C

6)Manual instruction&Cleaning Pin          

FAQ of OLinda Max 140 Bar High Pressure Car Washer

Q. What is the difference between PSI and GPM?
A. PSI is the pressure (lbs. per square inch) at which the water exits the nozzle. The GPM (gallons per minute) refers to the amount of water volume that exits the nozzle during a specified amount of time.

Q. Can I use hot water in my pressure washer?
A. The standard pressure washer is meant to be used with cold water. Using hot water in one of these machines could damage the pump.

Q. How do I change the nozzles?
A. The included nozzles have standard ¼” fittings that insert directly into the end of the spray wand by depressing the brass ring on the wand, inserting the nozzle, then releasing the ring. The nozzle should then “snap” into place.

Q. What cleaning solutions can I use in my pressure washer?
A. You should only use detergents that are designed for pressure washers. Other cleaners (like bleach) could damage your pressure washer pump.

Q. What is the cause of a "sputtering" type of sensation felt during operation?
A. Primarily after initial startup, residual air can still be trapped in the hose. Continue to hold down the trigger of the spray gun to allow the water to flow through the hose and expel any remaining air.